amsmarle
Mechanical
- Feb 17, 2003
- 29
Hello, can anyone advise on the following query's please,
1).
I have a large model produced in Inv 8 pro, (400 MB) with lots of pipe runs etc, and if I try to open it up in 2008 pro it finds lots of problems (can't find files), yet the same model runs perfect in Inv 8 pro ?.
2).
In Inv 2008 pro, the task scheduler will not open it just shows on the bottom task bar and then disappears after a minute. I am considering to try migrating all inv 8 pro files, but would like to know why model opens ok in ver 8 pro and not in 2008 pro?
3).
Does any of the Autodesk Inventor programmes give any problems in Vista.
Thanks for any help
amsmarle
1).
I have a large model produced in Inv 8 pro, (400 MB) with lots of pipe runs etc, and if I try to open it up in 2008 pro it finds lots of problems (can't find files), yet the same model runs perfect in Inv 8 pro ?.
2).
In Inv 2008 pro, the task scheduler will not open it just shows on the bottom task bar and then disappears after a minute. I am considering to try migrating all inv 8 pro files, but would like to know why model opens ok in ver 8 pro and not in 2008 pro?
3).
Does any of the Autodesk Inventor programmes give any problems in Vista.
Thanks for any help
amsmarle