Is it possible to rotate a sketch/or feature by 90 degrees

[bjohnson86]

Good morning all, and thank you again for your help. This is a wonderful website and I would be lost without your advise.

Is there a way to rotate previously made sketches or features by 90 degrees?

Thank you very much for your time,

Brandon

 

[BOPdesigner]

In the Sketcher, you can use the Reattach workflow to change the sketch plane and/or horizontal reference. If you want to reorient an entire body, you can use the move command (Ctrl+Shift+M).

 

[bjohnson86]

Thank you

 

[almakuch]

I presume that you datum CSYS to set you sketch up, if so you can rotate it 90, and everything else, "should" follow. Just as long all the constraints are within the sketch.