Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations pierreick on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ISO13445-3 Nozzle with reinforcing ring calculation

Status
Not open for further replies.

amm_naser

Mechanical
Jan 17, 2024
1
Hi,
I'm doing the check calculation per ISO 13445-3 for the reinforcing ring of the nozzle, and I'm having issues calculating the maximum lengths l0 of ring and the average thickness eam.

Firstly, there is an error in formula 9.5-47:
l0 = lr + (l0 - lr) - this makes no sense

But the l0 and eam are connected via 9.5-46 and 9.5-48, and this is not possible to calculate, or am I missing something?
1_mewx3h.png

2_p7pstj.png


Does anybody have the slightest idea how to calculate these values?

Thanks in advance!
 
Replies continue below

Recommended for you

Well, I spent two seconds looking at the page and spotted the words "by iterative calculation".
 
There’s no ISO 13445. I assume you mean EN 13445.

Huub
- You never get what you expect, you only get what you inspect.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor