Issue with NX assembly 1

[Shankarhs]

Hi,
I have NX 12 assembly which loads and shows position of components perfectly fine on system 'A' but the same assembly opened on any other system components would get dislocated. I have maintained load options too to be mirror image, so there's no problem with that. It's peculiar I can't figure out what's causing the issue. Has anyone encountered such scenario?

 

[Toost]

Arrangements ?
Revisions ? ( Managed / Native mode?)
Reference sets ?
Exploded Views ?

Regards,
Tomas

The more you know about a subject, the more you know how little you know about that subject.

 

[Shankarhs]

My observation is I add one of the local drive from where Library parts are picket up under loading options. Surprisingly when this library drive location is removed from loading options there is no problem.

But no library parts are loaded too for this assembly from that drive !!! it's crazy but works when drive is removed from NX load options...

 

[cowski]

Do either of the computers have copies of the parts on the local drive? If so, it may be loading the wrong "version" of your parts. After loading the assembly, go to menu -> information -> assemblies -> list components (or menu -> information -> part -> loaded parts) to see where the parts have loaded from. Do this on both computers and compare results.

www.nxjournaling.com