iTNC530 probing in ISO

[dmacc60]

I have written an ISO program for a HBM using a iTNC530 control, (except for the part probing routines.) I will have a Renishaw RMP60
part probe to use. How do I use the Heidenhain probe routines in an
ISO program?
In our other machines using Fanuc controls we just inserted a few
lines of code in the program to activate and run the probe. I have explored the Active Editor Pro software from Renishaw, and it appears cumbersome, and impossible to verify the output.
I am looking for any tips, samples of what other programmers are using for ISO programs in the iTNC530.

Thanks in advance

 

[moldmaker1001]

You should be able to insert the Heidenhain probe cycle into the program. Just insert your cycle def...then a cycle call...you can do right at the machine. Shouldn't be a problem....


Regards

 

[is2634]

I use the iTNC in conversational mode, but my probing manual shows commands such as G410 for ISO. Check out this link...

http://content.heidenhain.de/doku/tnc_guide/pdf_files/iTNC530/340422-xx/tchprobe/375_319-22.pdf