joedunai
Mechanical
- Mar 3, 2012
- 18
Hi Experts,
I am trying to run a trivially simple simulation, a ball moving within a cone.
If I don't add a 3D Contact - Force Joint between the ball and cone wall then the ball will fly through the wall.
If I add the Force Joint then I get the following error message:
"Joint force error: No face on `Ball:1` object, contact 3D with penetration impossible !"
Another weird problem is that if I remove the Force Joint and try to move the ball in "Dynamic Motion" mode no force is applied to the ball when moving cursor as it supposed to do.
Can somebody help find the solution to these problems?
The Assembly file is attached to this post.
Thanks in advance.
Joe
I am trying to run a trivially simple simulation, a ball moving within a cone.
If I don't add a 3D Contact - Force Joint between the ball and cone wall then the ball will fly through the wall.
If I add the Force Joint then I get the following error message:
"Joint force error: No face on `Ball:1` object, contact 3D with penetration impossible !"
Another weird problem is that if I remove the Force Joint and try to move the ball in "Dynamic Motion" mode no force is applied to the ball when moving cursor as it supposed to do.
Can somebody help find the solution to these problems?
The Assembly file is attached to this post.
Thanks in advance.
Joe