Keeping dimension/flagnote Facing Forward while Rotating Model 3

[bryjarmoc]

Bare with me as I am new to Catia software and UG software.

Is there the an option to set up the "dimensional callout displays" to always face "forward" while the model is rotated?
I want to capture the callouts in 2D, but when I rotate the model to show where a callout is "pointing" you can not read the display. When I rotate the model to read the display, I can not display (see in 2D) where/what feature the callout is referring to.

Hope this makes sense, and I apologize for my naiveness.

Anyhelp would be appreciated.

 

[J-C]

No way to do this in UG, something I miss from Solidworks.

Jason

 

[ewh]

I have not seen any setting to allow for this, and am not aware of enhancement of this type. You could try asking at the UG bbs

http://bbsnotes.ugs.com/

The UG developers keep tabs on that site, and may be able to give you a more definitive answer. You will need an install number to open an account there.

 

[motorsportsdesign]

NX4 has it

Jonathan T. Schmidt

http://www.schmidtmotorworks.com