knowledge fusion in solidworks 1

[puriddu]

Good morning. is it possible in solidworks use knowledge fusion? where i can found any guide about it?
thanks.

 

[CorBlimeyLimey]

The original producers of "Knowledge Fusion" was "Engineering Intent Corporation", but they have been aquired by Autodesk. It appears to work with UGS NX. I cannot find mention of it being used with SolidWorks.

However SW2006 has "Driveworks Express" built in. Also SolidWorks does have partners who offer KBE software.

http://www.solidworks.com/pages/partners/partnerList.html

Helpful SW websites FAQ559-520
How to get answers to your SW questions FAQ559-1091

 

[puriddu]

thanks a lot for the answer.

 

[puriddu]

excuse me CorBlimeyLimey do you know where i can found material about konwledge fusion in general? thanks

 

[CorBlimeyLimey]

Sorry, I do not. You will have to scour the web ... or maybe contact Autodesk to see if they offer anything.


Helpful SW websites FAQ559-520
How to get answers to your SW questions FAQ559-1091