Sep 24, 2007 1 #1 maryam1979 Materials Jul 17, 2005 11 Hi, is there anything in ASME about lamination test (UT) on plates over 20 mm in thickness?
Sep 25, 2007 #2 VaBeachZ Mechanical Nov 8, 2004 21 I would suggest looking into MIL-STD-810, Labratory testing procedures. Its not a detailed instruction, but gives a direction to go and you can fine tune it for your application. Everett#2390 Upvote 0 Downvote
I would suggest looking into MIL-STD-810, Labratory testing procedures. Its not a detailed instruction, but gives a direction to go and you can fine tune it for your application. Everett#2390
Sep 25, 2007 #4 JR97 Mechanical Feb 8, 2006 173 maryam, It depends on what section of the ASME Code you are working with. Section VIII Div 1 - no requirement Section VIII Div 2 - AM-203 - UT if over 4" Section III - NB-2531 - UT if over 2" I am sure there are different requirements in other sections. JR97 Upvote 0 Downvote
maryam, It depends on what section of the ASME Code you are working with. Section VIII Div 1 - no requirement Section VIII Div 2 - AM-203 - UT if over 4" Section III - NB-2531 - UT if over 2" I am sure there are different requirements in other sections. JR97
