DOES ANYONE KNOW WHAT THE CUTTING PROGRAM SHOULD BE FOR 24 GAUGE GALVANIZED? IM RUNNING A 1000 WATT MAZAK AND MY CUT SPEED IS 12O IPM AND IM CUTTING AT 600 WATTS BUT IM ENDING UP WITH A ROUGH CUT (BOTTOM SIDE OF PART HAS A BUR ON IT). THE PROGRAM IM RUNNING IS ACTUALLY FOR .035 CRS. I TRIED TO INCREASE AND DECREASE MY SPEED AND PLAYED WITH THE DUTY AND NOTHING SEEMED TO REALLY HELP.
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
LASER CUTTING 24 GAUGE GALVANIZED SHEETMETAL
- Thread starter CCARDINAL
- Start date
- Status
Similar threads
- Locked
- Question
- Locked
- Question