Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Laser Setting( Condition)

Status
Not open for further replies.

meps11

Materials
Nov 4, 2016
35
Lasering Galvanized 12gauge with 7 lens on a Mitsubishi lazer 3015ex what settings can I use thx.
 
Replies continue below

Recommended for you

You should have a book or pdf with cut conditions.
SECN7 or maybe GALV7
 
thx for the help but no pdf or book . the book itself tell you how to adjust it but dose not give a condition to start .Iam working from scrath can I use a amada setting seems that averyone uses those.
 
I can check our conditions but you need to cut it with nitrogen or shop air. You get poisinus gas if you cut with oxygen.
 
we also have nitrogen . thx for your help .If iam close I can adjust also I am using 7.5 len sorry but I do have 5 lens .
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor