Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Law Curves, associative origin and how to redefine origin for existing

Thread starter BOPdesigner
Start date Nov 10, 2010

Status: Not open for further replies.

Nov 10, 2010

BOPdesigner

Mechanical

I am working with law curves in NX6 and I can't seem to find where the Associative check box is when you get to the step to define the origin. Then for an existing curve when you edit with rollback you only have options to change the x,y,z parameters, how do you redefine the origin?