LC1212 ALPHA 2 Parameters 2

[giorgos1001]

Hi all,
My first time to post here.
I am a newbie on laser cutting machines and i have started recently to read the manual of the recently purchased amada lc1212 alpha 2.
At the beginning when i have first started the machine there was an SRAM PARITY ERROR. I have read the FANUC 16LB manual and it said that i can reset the memory and maybe the error will gone (that was caused because the machine was not working for a long period of time).

After i did that, i have found out that all the previously installed parameters were gone (i had to make a back-up, only if i knew before) and now i have now clue how to put them back and correctly.

Hope someone will help me with their experience or just guide me.

Sorry if my english is bad...not my native language.

Thanks in advance,

George

 

[laserdog]

Are you talking about all the cut conditions being gone?

 

[giorgos1001]

the parameters of over travel and some other staff, which i dont remember now as it is late evening here and i am not at the office. i will send you again tomorrow morning in detail.

Basically, what was saved on the memory masterboard has been deleted.

 

[LASERNINJA]

Wow. Hmmmm, that's not good. Did you get any floppy discs with the machine? It will help. What country are you located? You may need some professional help on this one.

 

[giorgos1001]

Unfortunately i did not get any disks with it. We are located in Cyprus, Europe. I am waiting for the distributor of amada in Greece (which is the distributor for Cyprus also) to give us an offer for coming to fix the machine, but at the same time i am looking if i can find out something.
I am thinking of taking step by step actions on the machine, maybe i can do something, the only thing is if you dont know, then dont do anything

 

[giorgos1001]

if somebody has the same machine and is willing to sell me a copy of their parameters backup i am very interested.

 

[LASERNINJA]

This is a start. I recommend printing a copy of these out and then typing them in very very carefully.

 

[LASERNINJA]

This may be a better place to start. If you look over this attached document, you can see there is a lot of information we need to load in to bring your machine back to life. Let me know when you are ready for more information. I will see what I candles find.

 

[giorgos1001]

Laserninja, thank you very very much. I will get to it and i will inform you.
Thanks again

 

[giorgos1001]

PROGRESS:
I have put all the parameters that you gave me, Laserninja and the machine is working manually, but at some point it gets an alarm when the x,y or z axis exceeds the limit. I dont know if that supposed to happen or this is how it works manually.

Tomorrow morning i will try again to go a step further, as tonight i will continue reading the operation manual.

thanks again for your unbelievable help.