sartorbjk
Mechanical
- Nov 12, 2009
- 55
Dear Ansys Users,
I am doing a warpage simulation.
I have a bi-layer material. Simulation starts at 150°C, it goes down to 25°C. At 150°C, the material is straight (like a rectangular box). At room temperature (due to different CTE of the materials which constitutes the bimaterial), material warps. I am just wondering, if there is a way to measure the length of the line after the warpage(It is the line which connects point a to point b along the line from the colorful picture)?
Best Regards,
Sartor
I am doing a warpage simulation.
I have a bi-layer material. Simulation starts at 150°C, it goes down to 25°C. At 150°C, the material is straight (like a rectangular box). At room temperature (due to different CTE of the materials which constitutes the bimaterial), material warps. I am just wondering, if there is a way to measure the length of the line after the warpage(It is the line which connects point a to point b along the line from the colorful picture)?
Best Regards,
Sartor