Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Limiting MAWP 1

Status
Not open for further replies.
hplogger

hplogger

Mechanical
Sep 23, 2007
14
Is it still acceptable that when considering all the MAWP per UG-98, the limiting vessel component is the nozzle based on the limiting MAWP computed? Please advise. Thank you in advance.
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Thank you guys for all your comments. The considerations are clear enough to me. Thank you once again.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

FPPE
  • Locked
  • Question
ASME VIII-1 MAWP and MAP calculation for flanged cover API 661 air-cooled
Replies
15
Views
185
TGS4
TGS4
Karthik P
  • Locked
  • Question
Non-Standard/Customised Flange MAWP 2
Replies
3
Views
71
LittleInch
LittleInch
mechengineer
  • Locked
  • Question
Whether we shall consider MAWP for tubes in the heat exchangers design? 1
Replies
4
Views
130
mechengineer
mechengineer
sarawana
  • Locked
  • Question
calculation of MAWP Reduction Due to External Loads
Replies
1
Views
119
GandalfTheGrey
GandalfTheGrey
Anthony Aponte
  • Locked
  • Question
ASME VIII DIV. 2 PAR. 5 - SELF LIMITING STRESSES
Replies
2
Views
68
Snickster
Snickster

Part and Inventory Search

Sponsor

Back
Top Bottom