Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Line moving when printing in catia

Status
Not open for further replies.

Jacques Dubois

Mechanical
Jul 29, 2020
2
CH
Hello,

I'm a designing new drawings for a mechanical part. In my drawing i have to create a line that represents the middle of the object. To do so i use a bissector line between the two exteriors (parrallels)lines. Everything is fine as long as it is on the screen, but for an unknown reason, when i print it, the line moves and isn't placed at the center anymore. Have you already experiences that kind of problem ?

Thank you for your help,
Best regards,
Jacques
 
Replies continue below

Recommended for you

What if you save the drawing as a .pdf file.
Is the line within the .pdf off-center?
 
Thank you for your answer,
Yes, even when I try to save it as a PDF it moves the line in the same way.
 
Try changing the view generation in view properties.

ViewGen_xs62ly.png
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top