linear rising guide

[helpersnx]

I don't know how, but I think you Know
I want to create a linear rising groove. I have attached (nx6) a file where the guide for the groove is fixed in the sketch. I want a linear rising guide from for ex. start 0 and 3mm in z at the end. How can I do this in Nx?
regards

 

[eex23]

look at the attached. is this as you want?
(i am on nx7, so you will not be able to open my prt in nx6...)

 

[helpersnx]

yes, that it

 

[helpersnx]

second problem is close to the first,
How can unwrap a sketch on a tapered zylnder?
In the file attached I created / rebuild the geometry.
regards

 

[JohnRBaker]

Does this give you what you're looking for (see attached example)?

John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

http://www.plmworld.org/museum/

To an Engineer, the glass is twice as big as it needs to be.

 

[helpersnx]

Thx John, nice really fast response,
I have looked a yor file, hmm?!,
Maybe you look at the hidden body on layer 2.
I have do redesign, or another idea?
regards

 

[JohnRBaker]

This is actually a better result (I didn't quite get the last feature right).

John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

http://www.plmworld.org/museum/

To an Engineer, the glass is twice as big as it needs to be.

 

[helpersnx]

thanks again John,
that closer to the hidden geometrie, thx.
the leads to the next problem, using the guide curves (single selected path) in tube, sweep,... the path nx message :
Nonlinear guide objects must be smooth with a continuous tangent.
regards

 

[eex23]

Here is your linear rising guide in NX6.
I think you will understand the idea of this.