I often receive dwg files from architects / engineers that have duplicate lines stacked on top of each other. I assume this is from multiple xrefs on top of one another. Is there a command in Autocad that will delete the unnecessary lines? Thanks in advance for any replies.
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Lines on top of lines, on top of lines......
- Thread starter ryano669
- Start date
malaycobra
Civil/Environmental
I heard also that in the days of pen plotters, draftsmen would draw multiple lines to achieve different line thicknesses.
When the pen got to one of these lines, the pen would go back and forth and the ink would spread, thus getting thicker!
Specialists in Heavy-Lift and Transport Planning
When the pen got to one of these lines, the pen would go back and forth and the ink would spread, thus getting thicker!
Specialists in Heavy-Lift and Transport Planning
- Status
Similar threads
- Locked
- Question