Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

linetype issue

Status
Not open for further replies.

hayeska

Structural
Dec 28, 2003
46
My lineype is set as continuous in the Layer Properties Manager but shows as dashed when drawn.

When listed, the property is dashed for line type.

I can change the property of the line using DDMODIFY.

This happens to all layers no matter what linetype is designated in the Layer Properties Manager.

There must be some type of overide.

Any solutions?

Thanks in advance
 
Replies continue below

Recommended for you

There is a setting for "current" linetype, as there is for color.
I believe that setting (variable) is "celtype", you should set it to "bylayer".
 
It was set to dashed.

Don't know how it changed.

Thanks
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor