Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

linking sketch text

Thread starter 2Dto3D
Start date Jul 12, 2002

Status: Not open for further replies.

Jul 12, 2002

2Dto3D

Mechanical

Is there a way to link sketch text to properties? I have a crank with several lengths possible. The length of the crank will be engraved on it. I know I can have a feature for each configuration and just supress the ones that don't apply (I would do this in a design table, of course), but is there a simpler way, such as linking the text to a configuration specific property? Charley Leonard
CSWP

http://www.2dto3d.com