Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Linking User Parameters Part to Drawing:

Status
Not open for further replies.

tsqman

Mechanical
Mar 22, 2002
36
Hello Everyone:

A question came up last week that I thought would be simple to solve but it has been a bit of a challenge and I have run out of ideas.

Question:
I would like to link a boolean User Parameter on a CATDrawing to a boolean User Parameter on a CATPart (CATPart being the parent) see attached image. The difficulty comes from the Tools/Options/Part Infrastructure/General is locked see attached image.

CATIA V5R17 R8 Windows XP Pro
Thank You in Adance
TSQMAN
 
Replies continue below

Recommended for you

i don't think you can.
you have to talk to your CATIA admin and explain him/her the need you have and ask them for a solution.



Eric N.
indocti discant et ament meminisse periti
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor