Jul 20, 2007 #1 steeltwon Structural Jul 20, 2007 2 Can someone give me the load calc for a 3/8"x8"x14'span Flitch plate between 2 2x10's
Jul 20, 2007 #2 UcfSE Structural Dec 27, 2002 2,525 thread507-188799 This article is a good source. The rest is basic mechanics of materials. You check the transformed section as wood and as steel for both bending as shear and use the one with the least strength for design. Upvote 0 Downvote
thread507-188799 This article is a good source. The rest is basic mechanics of materials. You check the transformed section as wood and as steel for both bending as shear and use the one with the least strength for design.
Jul 20, 2007 Thread starter #3 steeltwon Structural Jul 20, 2007 2 Thanks for your post.. B Upvote 0 Downvote
Jul 20, 2007 #4 MiketheEngineer Structural Sep 7, 2005 4,654 Check out http://www.beamchek.com. Their software will handle this and is about $150.00 Upvote 0 Downvote
Jul 20, 2007 #5 MiketheEngineer Structural Sep 7, 2005 4,654 Check that - I just rechecked it and it does not do exaclty what your are looking for .... Sorry Upvote 0 Downvote
Jul 20, 2007 #6 jwilson33 Structural Jul 20, 2005 26 StruCalc v7.0 will do flitch plate design with most any wood type. I haven't used that module yet to comment on the results. Jim Upvote 0 Downvote
StruCalc v7.0 will do flitch plate design with most any wood type. I haven't used that module yet to comment on the results. Jim
Jul 20, 2007 #7 COEngineeer Structural Sep 30, 2006 1,186 JWILSON, I have struc Calc v6.0. Is it worth the money to upgrade it? http://www.swijetty.comSea Water Intake and Jetty Construction Upvote 0 Downvote
JWILSON, I have struc Calc v6.0. Is it worth the money to upgrade it? http://www.swijetty.comSea Water Intake and Jetty Construction
