Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Lost Toolbar
- Thread starter Cargeke
- Start date
JohnRBaker
Mechanical
In NX 5 and NX 6, try going to...
Preferences-> User Interface -> Layout
...and in the 'Settings' section, select the 'Reset Windows Position' reset button.
In NX 3 and NX 4, try going to...
Preferences-> User Interface -> General
...and the select the 'Reset Windows Position' button at the top of the dialog.
John R. Baker, P.E.
Product 'Evangelist'
NX Design
Siemens PLM Software Inc.
Cypress, CA
To an Engineer, the glass is twice as big as it needs to be.
Preferences-> User Interface -> Layout
...and in the 'Settings' section, select the 'Reset Windows Position' reset button.
In NX 3 and NX 4, try going to...
Preferences-> User Interface -> General
...and the select the 'Reset Windows Position' button at the top of the dialog.
John R. Baker, P.E.
Product 'Evangelist'
NX Design
Siemens PLM Software Inc.
Cypress, CA
To an Engineer, the glass is twice as big as it needs to be.
- Thread starter
- #3
- Status
