Oct 17, 2008 #1 Cargeke Bioengineer Jul 29, 2008 28 0 0 US I seem to have misplaced my Assemblies toolbar and I can't find it. I turned off all the other toolbars while leaving the Assemblies checked and it doesn't reappear. Is there any way to make it reappear? Thanks, Jim
I seem to have misplaced my Assemblies toolbar and I can't find it. I turned off all the other toolbars while leaving the Assemblies checked and it doesn't reappear. Is there any way to make it reappear? Thanks, Jim
Oct 17, 2008 #2 JohnRBaker Mechanical Jun 1, 2006 35,343 2 38 US In NX 5 and NX 6, try going to... Preferences-> User Interface -> Layout ...and in the 'Settings' section, select the 'Reset Windows Position' reset button. In NX 3 and NX 4, try going to... Preferences-> User Interface -> General ...and the select the 'Reset Windows Position' button at the top of the dialog. John R. Baker, P.E. Product 'Evangelist' NX Design Siemens PLM Software Inc. Cypress, CA http://www.siemens.com/plmhttp://www.plmworld.org/museum/ To an Engineer, the glass is twice as big as it needs to be. Upvote 0 Downvote
In NX 5 and NX 6, try going to... Preferences-> User Interface -> Layout ...and in the 'Settings' section, select the 'Reset Windows Position' reset button. In NX 3 and NX 4, try going to... Preferences-> User Interface -> General ...and the select the 'Reset Windows Position' button at the top of the dialog. John R. Baker, P.E. Product 'Evangelist' NX Design Siemens PLM Software Inc. Cypress, CA http://www.siemens.com/plmhttp://www.plmworld.org/museum/ To an Engineer, the glass is twice as big as it needs to be.