May 12, 2006 #1 ncoon Structural Mar 1, 2006 5 0 0 CA Anybody know if its possible to get low temp steel in rolled sections? Specifically Japanese mills? Failing that German mills? Thanks in advance.
Anybody know if its possible to get low temp steel in rolled sections? Specifically Japanese mills? Failing that German mills? Thanks in advance.
May 14, 2006 #2 tobbe Structural May 19, 2003 17 0 0 SE If you are looking for angle bars or of bulb flats Norskt Stål (http://www.norskstaal.no) can supply a selection of dimension in D36-quality. Bulbs: http://www.norskstaal.no/varekatalog/varekatalog.aspx?varegr=13_1# Angles: http://www.norskstaal.no/varekatalog/varekatalog.aspx?varegr=14_1# Regards T. Upvote 0 Downvote
If you are looking for angle bars or of bulb flats Norskt Stål (http://www.norskstaal.no) can supply a selection of dimension in D36-quality. Bulbs: http://www.norskstaal.no/varekatalog/varekatalog.aspx?varegr=13_1# Angles: http://www.norskstaal.no/varekatalog/varekatalog.aspx?varegr=14_1# Regards T.