Low Temperature Structural Steel

[proejuan]

Is good the ASTM A36 for low temperature sites (-58 degrees F) or what is the yield strenght under this temperature?

 

[ishvaaag]

http://cr4.globalspec.com/thread/2947/Temperature-and-A36-Structural-Steel

http://www.eng-tips.com/viewthread.cfm?qid=204501&page=28

In Spain the selection of the steel as a function of temperatue of service is made based in tables in the governing code CTE, which is not directly ASTM related.

 

[slickdeals]

@Ishvaaag,
Long time no see. Good to have you back. The forums were becoming strictly engineering and missing the poetic aspect of your replies.

We are Virginia Tech
Go HOKIES

 

[ishvaaag]

Heh, thanks, slickdeals... I am learning (to where I can) new things, 3D representation mainly... and time is difficult to stretch. I have no plans however about letting my contributions to this fine site come to any definitive end ... even if have stopped doing so before for years. Simply, to extract time for things is very difficult I think for everyone, and so is the case for me, always with so many subjects and commitments going in my mind.