Macro to close spline in drafting

[Kenevil]

After defining spline points on a drawing, I right click on the spline, go to a sub menu and then check the "close spline" box. Easy but I am doing this a lot so I unsuccessfully attempted to record a macro. Any suggestions on how to accomplish this?

 

[drewmumaw]

@Kenevil
Off the top of my head (don't have access to CATIA at the moment) I'm am fairly certain that it's impossible to do this via a macro given the API. However, I was trying to do it with splines in the sketcher workbench. Although I'm assuming that if a spline can't be closed via a macro in the sketcher workbench, then it can't be done in the drafting workbench either. I think you would need CAA.

Regards,
Drew Mumaw

http://www.drewmumaw.com/

http://www.textsketcher.com/