Hello, I have this assembly that looks exactly how I want it to, but then when I look at the assembly that I put it into, there is an extra part there that was probably deleted at some poin but still shows up in the upper level. Using Solid Edge ST2, any help is appreciated. Thanks.
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Magic Part
- Thread starter ajs4653
- Start date
- Status
Similar threads
- Question
- Question
- Locked
- Question