Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Magnets for tool bits 1

Status
Not open for further replies.

mckeand13

Mechanical
Sep 20, 2002
37
US
I've seen and used before round magnets that slip over a screwdriver bit to hold a fastener for assembly. They are about 1/2" in diameter and 3/8" in height. Different color plastic covers.

I can't figure out where to buy them from though? I thought I got them from McMaster before but can't find them there.

Any ideas?
 
Replies continue below

Recommended for you

Do you have a direct link by chance? I checked all of those places and couldn't find anything.
 
I just asked a co-worker and he knew.

These are what I am talking about. I guess my search is over.

Thanks for the replies.


GetImage.asp
 
mckeand13,

Thanks for letting us know the solution and posting the link. I'm sure some others amongst us will be able to find use for these magnets.



Alan M. Etzkorn [machinegun] [elk]
Reliability Engineer
Wabash National Corp.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top