How can I make a pipe or a cylinder from a line? Have made a framework for a suspension on a car with lines and want to give them radious. There must be a easy way to do this. Or does I have to use the sweep or revolve commands?
which is very close to what you need to do.
Equipment and Systems -> Tubing. (you need to go through the Help tutorial in order to get a grisp on the procedure,setings,etc. )
There is also a BIG disadvantage in the method:
-You can't do nothing with the tubing "model"...so, first do a test run and see if this is what you are looking for, before comit to the full frame.
If I can do it you can do it too!! GOOD LUCK!
Regards,
Mircea