Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Make copied part independent

Status
Not open for further replies.

Hepcat2

Industrial
Dec 28, 2009
2
How do you make a copied part independent? That way you can edit it without all the other parts changeing as well.
 
Replies continue below

Recommended for you

Open a new drawing, copy the part, rename it within a new opened file, then copy and paste renamed file back to original drawing file. Hope this helps.
 
Thanks for the response. I have found that instead of copying the part, you can copy either instance or deffinition, I forget which one, and that makes the copied part act as an independent part.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor