Make coplanar with ST command

[cubalibre000]

Hi,
I attach a part and an image.
I would like to make coplanar a face to another in sheet metal.
I can't able to accomplish this operation.
Can someone suggest me something ?

Thank you...

Using NX7.0 and TC8.1

 

[uwam2ie]

use replace face its doing the same thing - look that the selection focus is on intire assembly

 

[cubalibre000]

Hi uwam2ie,
doesn't work.
Can you try to obtain the needing with the part that I attached before ?

Thank you...

Using NX7.0 and TC8.1

 

[uwam2ie]

Ok , now I had looked at your part wioth Nx7.
It is done in Nx sheetmetall - I'm still examine.
Question I have , why don't you pull you flange parameters
to 90° ? the other thing is - that flatting doesn' t work;too.
...

 

[JohnRBaker]

I thought we had already covered this subject once before, didn't we? Generally speaking, you can NOT use ST on Sheet Metal models and have them continue to behave as if the part was modeled using Sheet Metal features. It's just not possible with the current set of tools.

John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

http://www.plmworld.org/museum/

To an Engineer, the glass is twice as big as it needs to be.

 

[cubalibre000]

Hi John,
it's true, we had already covered this part, but I've changed something and now I can't able to obtain as before.


Thank you...

Using NX7.0 and TC8.1