nxexplorer
Mechanical
- Jun 23, 2010
- 84
Hello,
I need help on postprocessing stage to be customized.
What I need is to make Warning when postprocessing, if gauge check has not been done, NX will say "Postprocess is aborted, Please do the Gauge Check!".
And when gauge Check has been done, There is no Warning.
Someone has doing this with good result, please share me how the way.
Thank you,
With Regards,
NXExplorer
I need help on postprocessing stage to be customized.
What I need is to make Warning when postprocessing, if gauge check has not been done, NX will say "Postprocess is aborted, Please do the Gauge Check!".
And when gauge Check has been done, There is no Warning.
Someone has doing this with good result, please share me how the way.
Thank you,
With Regards,
NXExplorer