Jun 26, 2006 #1 agdyp Mechanical May 11, 2006 13 0 0 US I'm looking to find a manufacturing process for MASS production of a steel tube. OD is 5mm and wall thickness is .35mm. Any ideas/suggestions will be appreciated. Thanks.
I'm looking to find a manufacturing process for MASS production of a steel tube. OD is 5mm and wall thickness is .35mm. Any ideas/suggestions will be appreciated. Thanks.
Jun 26, 2006 #2 TVP Materials Apr 12, 2002 4,592 0 0 US What is the length requirement? Upvote 0 Downvote
Jun 26, 2006 #3 TVP Materials Apr 12, 2002 4,592 0 0 US What steel grade is required? Can it be stainless steel? If so, Eagle Stainless Tubing routinely makes very small diameter tubes in this range. Their website is http://www.eagletube.com Upvote 0 Downvote
What steel grade is required? Can it be stainless steel? If so, Eagle Stainless Tubing routinely makes very small diameter tubes in this range. Their website is http://www.eagletube.com
Jun 26, 2006 Thread starter #4 agdyp Mechanical May 11, 2006 13 0 0 US Sorry I didn't mention this before. Material is 304 Stainless Steel and length is 6mm. Thank you for your response. Upvote 0 Downvote
Sorry I didn't mention this before. Material is 304 Stainless Steel and length is 6mm. Thank you for your response.
Jun 26, 2006 1 #5 unclesyd Materials Aug 21, 2002 9,819 0 0 US Here is another one that I've used with very good results. http://www.minitubes.com/etirage.htm Upvote 0 Downvote
