Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SSS148 on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

manufacturing process for 0.35mm wall steel tube 1

Status
Not open for further replies.

agdyp

Mechanical
May 11, 2006
13
I'm looking to find a manufacturing process for MASS production of a steel tube. OD is 5mm and wall thickness is .35mm.

Any ideas/suggestions will be appreciated.

Thanks.
 
Replies continue below

Recommended for you

What is the length requirement?
 
What steel grade is required? Can it be stainless steel? If so, Eagle Stainless Tubing routinely makes very small diameter tubes in this range. Their website is
 
Sorry I didn't mention this before. Material is 304 Stainless Steel and length is 6mm.
Thank you for your response.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor