Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Markings on hooks

Status
Not open for further replies.

Guideon

Mechanical
Dec 11, 2006
22
0
0
IL
Dear sir

I found out that some of the hooks (crosby's & other's) are marked with two numbers separated by hyphen such as 13-8, 10-8, 7/8-8.
What these numbers (the first number and the second number) mean?
Is these numbers come from standard requirement? If positive – please note the standard.

Thank you
Guideon
 
Replies continue below

Recommended for you

Status
Not open for further replies.
Back
Top