Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Mass Properties in BOM

Status
Not open for further replies.

Edscad

Mechanical
May 8, 2012
1
I am using Mechanical Desktop 2005. When I go to “Assembly”, “Analyst”, “Mass Properties”, and add a material to my parts: When I click “Calculate” on the “Results” tab, the “Mass” is correct. However, when I insert my BOM on to my title block in Layout, the “Mass” column always shows “1.000”. It never shows what is shone “Results” under “Assembly Mass Properties”. Is this an error in the program, or is there a variable I need to change? Thank you for your replies!!!!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor