Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Reference dims in drawing mode will not scale

Status
Not open for further replies.

Mechduff

Industrial
Aug 2, 2010
2
I am working to dimension parts in mechanical desktop 8 and can't get the size of the dimension itself (dimscale) to change to something large enough to see when printed. at the command line "dimscale" will show for example 4.000 but the dim will come in at 1.000. Installed service pack 2 and it didn't help. Tried options/am standards/dimension etc no luck. It has been a frustrating couple of hours. Any help would be appreciated.
Thanks
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor