Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

material advice

Status
Not open for further replies.

slickfit

Materials
Dec 29, 2007
2
0
0
US
i need to machine a 3/4 inch axle (rear) for a custom i'm building. i was wondering what grade of steel would be best.
4140, 1144 etc.
 
Replies continue below

Recommended for you

Status
Not open for further replies.
Back
Top