Material Identification 2

[prady22]

Experts,

Recently, we got a additional work to perform in BOP piping. In that drawing list, Under bill of materials i saw in the material column "ASME B36.10". So what does it mean?? If i referred the particular section under para 3, nothing illustrate there. Actually, i have to choose proper WPS.

Attached pict for all your reference.

Lemme come out from this

 

[DSB123]

it is the dimensional standard for wrought steel pipe.

 

[prady22]

@DSB123,

Yeah Noted..!! Any additional information about the materials???

 

[europipe]

Nothing is filled in below middle, can't you get hold of the pipespec.?

 

[DSB123]

No materials mentioned - only the pipe and fittings dimensional standard. You need to get the Pipe Spec as europipe says.

 

[piper1982]

Dear Prady22,

The isometric which has been shared has lot of information missing. Is this the same isometric which was Issued for construction and is being used for redlining now for additional work.

An IFC isometric must have Piping material specification, Fluid code, temperature, pressure, insulation thickness, coating requirement, PID number mentioned, which are missing in the isometric shared by you.

Thanks