Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Material (PLASTIC) needed

Status
Not open for further replies.

Jack1_2-3_4-5_

Materials
Dec 20, 2016
8
IM
Hello

I am designing a tool holder for a motorcycle, that will come in contact with many chemicals on and around the motorcycle.
I have selected HDPE to manufacture it out of injection moulding.
Is there any other materials (plastic) that I could use.??? [smile2][smile2]
 
Replies continue below

Recommended for you

I would look at glass filled nylons.

----------------------------------------

The Help for this program was created in Windows Help format, which depends on a feature that isn't included in this version of Windows.
 
Actually I think you could try PP too. It is widely used to produce this kind of box/case in China. ABS is expensive, while PE is not so tough like PP.

Expert of nucleating agents
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top