Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Mathcad Prime 3.0 Matrix Help

Status
Not open for further replies.

MindofBarca

Structural
Mar 7, 2013
36
All,

I am trying to set up a Mathcad Spreadsheet for precast header design. I am currently checking my angle moment capacity and LTB. While doing so I am trying to find r(sub Z) which takes the square root(Iz/AL). For some reason this equation is spitting out a matrix. Then when I go to input rZ into my Me equation I am getting an error. Any help or input would be appreciated.

See attached spreadsheet.
 
Replies continue below

Recommended for you

Upon further review I was able to figure out what the problem was. Thank you.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor