Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Max. Interpass for Hardfacing

Status
Not open for further replies.
newweldeng09

newweldeng09

Mechanical
Oct 31, 2008
84
The maximum interpass temperature for production hardfacing cannot be exceeded per QW-406.4. Is it possible that when welding a multi-layer, (also multi-pass), weld continuously that the measurement of the interpass temperature does not apply?
 
Replies continue below

Recommended for you

Sort by date Sort by votes
No, that is the purpose for having an interpass temperature; to control or limit the amount of heat into a weld region.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

milosd
  • Question
ASME SB-564 Maximum section thickness for N06625
Replies
1
Views
1K
EdStainless
EdStainless
FAHADRANA
  • Question
WQT for Combination of Welders as per ASME Sec IX
Replies
1
Views
2K
weldstan
weldstan
teokal
  • Question
Saddle calculations for ASME VIII Div.2 Pressure Vessel - paragraph 4.15
Replies
0
Views
988
teokal
teokal
M
  • Question
SCL Placement for Fillet Welds in ASME VIII Div. 2 DBA
Replies
10
Views
2K
Mecat24
M
Bharanirajali
  • Locked
  • Question
According to para. 323.2.2 for lowe
Replies
0
Views
117
Bharanirajali
Bharanirajali

Part and Inventory Search

Sponsor

Back
Top Bottom