gsyrett725
Mechanical
- Oct 12, 2012
- 14
I am having trouble narrowing down a cutting condition that is consistent for a 20 degree bevel on a space gear MKII 4k watt laser. I am cutting am 0 shaped part that is beveled 20* towards the inside and 20* towards the outside. creating a A shaped profile for the part. The cut is leaving very deep gouges in the cut as it goes threw the radius. I have tried to speed it up and slow it down from 600 to 1500mm. Different watts from 2800 up to 4000. when I get a decent cut on the part the dross is so thick that I is very difficult to get the part out.
latest cutting condition is
G13 P500
G32 P1 T5 RO
M32
M22
GO1 S4000 P750 Q80 S1250.0
FOCUS AT 1 MM FROM TIP
2.0 TIP
stock condition that leaves the part unable to remove from the sheet
G13 P0
G32 P1 T3 R0
M32
M22
G01 3200 P500 Q100 F1000.0
same focus and tip.
thanks in advance
latest cutting condition is
G13 P500
G32 P1 T5 RO
M32
M22
GO1 S4000 P750 Q80 S1250.0
FOCUS AT 1 MM FROM TIP
2.0 TIP
stock condition that leaves the part unable to remove from the sheet
G13 P0
G32 P1 T3 R0
M32
M22
G01 3200 P500 Q100 F1000.0
same focus and tip.
thanks in advance