Mar 27, 2013 #1 kukelyk Industrial Mar 21, 2005 315 I think I can do this through Information window and manual selection. I hope You have easier way.. ---- kukelyk
I think I can do this through Information window and manual selection. I hope You have easier way.. ---- kukelyk
Mar 27, 2013 #2 jerry1423 Mechanical Aug 19, 2005 3,428 There probably is an easier way, But can you explain better what you are trying to accomplish ? Upvote 0 Downvote
Mar 27, 2013 Thread starter #3 kukelyk Industrial Mar 21, 2005 315 Thanks for Your attention. When positioning part for NC setup, I used to measure (minimum clearance) distance of WCS origin to solid body. The measurement is the value of the needed transition. ---- kukelyk Upvote 0 Downvote
Thanks for Your attention. When positioning part for NC setup, I used to measure (minimum clearance) distance of WCS origin to solid body. The measurement is the value of the needed transition. ---- kukelyk
Mar 27, 2013 Thread starter #4 kukelyk Industrial Mar 21, 2005 315 ..when repositioning part.. ---- kukelyk Upvote 0 Downvote
Mar 27, 2013 #5 JohnRBaker Mechanical Jun 1, 2006 36,130 The only 'easier way' would to write a simple program to do this for you since there's nothing built into NX to perform this task as described. John R. Baker, P.E. Product 'Evangelist' Product Engineering Software Siemens PLM Software Inc. Industry Sector Cypress, CA Siemens PLM: UG/NX Museum: To an Engineer, the glass is twice as big as it needs to be. Upvote 0 Downvote
The only 'easier way' would to write a simple program to do this for you since there's nothing built into NX to perform this task as described. John R. Baker, P.E. Product 'Evangelist' Product Engineering Software Siemens PLM Software Inc. Industry Sector Cypress, CA Siemens PLM: UG/NX Museum: To an Engineer, the glass is twice as big as it needs to be.
