Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Measurement annotations display in NX 1919

Thread starter ranjithbelur
Start date Mar 28, 2022

Status: Not open for further replies.

Mar 28, 2022

ranjithbelur

Automotive

Hi, I am using NX 1919. When we have a section in 3D, and tried to measure a distance with the display annotation option on. The measurements are not showing properly i.e, they seems they are not on section plane. Is there any settings to solve this? Also the measurements becomes tiny when zoomed out, which was not the case in earlier versions.