leo81
Bioengineer
- Dec 6, 2007
- 43
Dear all,
i'd like to simulate a rectangular membrane clamped on two ends imposing a perpendicular load in the middle.
To do this I have to prestress the membrane in its two planar directions. Do you know how to set the prestress?
Thank you very much
Leo
ps: I attached the file
i'd like to simulate a rectangular membrane clamped on two ends imposing a perpendicular load in the middle.
To do this I have to prestress the membrane in its two planar directions. Do you know how to set the prestress?
Thank you very much
Leo
ps: I attached the file