Mesh help!

[frdlive]

Hi guys

How can I edit the mesh on assembled part which is contain of three different parts?

Do I have to reassemble them again to edit their meshes?

Thanks

Frd

 

[IceBreakerSours]

You can edit the mesh both in the part as well as the assembly module. However, you get more options in the part module. So, if you do not have the required option in the assembly module, you have no choice but to edit it in the part module and create another instance and set up your assembly.

Are you new to this forum? If so, please read these FAQ:

http://www.eng-tips.com/faqs.cfm?fid=376

http://www.eng-tips.com/faqs.cfm?fid=1083

 

[frdlive]

Thank you Ice, but i think it takes very long time to do all these steps again and again, I am sure there is a solution for this issue.

The message that I have got is attached:

Thanks alot

Frd

 

[frdlive]

Sorry, the link is below:

Link

 

[IceBreakerSours]

You will need to use the Part module to edit your orphan mesh.

I am not sure if I understand why this is hassle. Do you want to upload a few pictures or a movie demonstrating what the problem is?

Are you new to this forum? If so, please read these FAQ:

http://www.eng-tips.com/faqs.cfm?fid=376

http://www.eng-tips.com/faqs.cfm?fid=1083