malisle
Electrical
- Jan 16, 2012
- 2
Hello!
I made a coil using the winding tool in Ansys 11. In order to perform a magnetostatic analysis, mesh must be applied to the winding body representing the coil. The problem is that I always get the message:
Error: A mesh could not be generated using the current meshing options and settings. Hint: The problem geometry areas might have been highlighted. Switching to wireframe mode may make them more visible. Project>Model>Mesh
I would appreciate any help.
I made a coil using the winding tool in Ansys 11. In order to perform a magnetostatic analysis, mesh must be applied to the winding body representing the coil. The problem is that I always get the message:
Error: A mesh could not be generated using the current meshing options and settings. Hint: The problem geometry areas might have been highlighted. Switching to wireframe mode may make them more visible. Project>Model>Mesh
I would appreciate any help.