Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations Toost on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

metal deck 2

Status
Not open for further replies.

valdeng

Structural
Nov 16, 2004
10
I am looking for info on 4 1/2" deep metal deck called out as "section 12-18 ga." on a Canadian drawing from 1959. Thanks.
 
Replies continue below

Recommended for you

Any other information? I've not heard of this.

Dik
 
Does the 12/18 designation mean 12" coverage and 18 ga mat'l for both or is it 12ga and 18ga? I didn't realize that deck came in 4-1/2" depth...

Dik
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor